- Order number: ESK8B11101
Custom made Limited Edition V2
Lower Plate 6mm Alloy 7075 works as a Heatsink
Middlepart 25mm POM
Upper Part 6mm Alloy 7075 with custom Skull Design
Around 550gramm total, so not ultra light but Sexy as Hell and a very clean Mounting solution
Direct Mounting without drilling new holes in your brand new Trampa Deck
Fits Holy Pro and Standart Bolting Holes from Truck
Only outer Springposition or Inner if Adjusters flush with Deck
Possible tilt of reartruck depending on Motorsize and Drive around 20degrees
Not waterproof, but maybe splashproof (-;
1-Mount Lower plate with includet longer M5 Countersunk Screws
2-Mount Middle Part with two flat head screws from below
3-Mount Vesc6 from Top with M4 Screws
( use only 2 per Vesc and avoid the position where you can sqeeze the Vesc Lid)
4-Prepare your wires with Gaskets
5-Place RCX and BT modules inside
6-Mounting Lid with 2x short M5 into middle Part and 6x longer M5 right into lower Heatsink