No results were found for the filter!
FLIPSKY 2.4G Nano Remote Controller
Features: Supports 2-speed modes: High speed (1.5-2) Low speed (1.5-1.7) Leds: Green: Low voltage alarm and connection loss alarm Red: Charging indicator Extension modulator switch: Second channel for switching light or loudspeakers...
Servo Splitter 1 female to 5 male
With this servo Splitter you can share the signal of the remote control to 5 ESCs,perfect for a four-wheel electric skateboard. The cable has a length of 60mm 1 x standard servo connector female 5 x male pin plug
Maytech Remote 2017 Model
The remote control works on 2.4GHz and has 40bit wide ID code (over a trillion IDs) for pairing. The interference of the remote controls is therefore very unlikely. Give your throttle and brake your thumb with this remote control. The...
Maytech Remote 2.4 Ghz
A small and light 2.4 Ghz Remote Control made by Maytech. The remote has an integrated Li-Ion battery, which can be recharged using the included USB-Cord. The battery status is displayed using LEDs. Furthermore included are a strap to...
Nunchuck LiPo Tuning Kit 320mAh
This set consists of a 1S LiPo battery with a nominal voltage of 3.7V and a capacity of 320 mAh and a charging circuit capable of up to 500 mA charging current, but preset for 300 mA. This kit is especially designed for the nunchuck...
Electronic Remote Switch
With this electronic switch you can finally utilise that extra channel on your remote. It enables you to switch auxiliary electronics like LED lights on and off with your remote. Tech Specs: Weight: 12g Input Voltage: 4 - 8,4V Maximum...
Content 1 Pieces
Quanum 2.4 Ghz Pistol grip Remote and Receiver Set
This Pistol grip Remote-Control-System is tried and true among electric skateboard riders. The 2.4 Ghz RF Technology is adequately protected against interference. The pistol grip holds nicely in your hand and the all the controls are in...
APS 2,4 GHz Remote with receiver
2.4 - 2.48 Ghz Remote and Receiver Band: 160 Range: Max 100 Meters Fail Safe Available: At loss of signal or low battery the receiver switches acceleration to neutral, so your board will decelerate slowly to a standstill Connection via...