No results were found for the filter!
VESC 6 PPM Cable
Connection cable for VESC 6 to connect the receiver of your RC remote control. Cable length: 150mm (without the sockets)
From €5.00 *
VESC Hall Sensor Adapter Connector
VESC adapter connector for Hall Sensors Cable length: 150mm (exclude connector)
From €5.50 *
Heat-Shrink Tubing 10cm
A 10cm long piece of shrink tubing in various colors and diameters with a shrink rate of 2: 1 and a shrink temperature of 125 ° C.
From €0.05 *
Servo Splitter 1 female to 5 male
With this servo Splitter you can share the signal of the remote control to 5 ESCs,perfect for a four-wheel electric skateboard. The cable has a length of 60mm 1 x standard servo connector female 5 x male pin plug
Antispark Highvoltage Connector Plug
Battery connector plug QS-8S (male & Female) with 5,1ohm resistor. This plug is the best on the planet for your electric skateboard you can buy. The large, handy blue housing avoids the fiddling when connecting and disconnecting the...
APS USB to Serial-TTL Adaptor
This USB adaptor makes programming your alien ESC a breeze! Simply install the driver (which you can find here), install the ESC management software (can be found on the page of your ESC), connect the cable to the PC and that's it. But...
CAN-Bus cable for VESC controllers
Utilizing this handy little cable, you can connect two VESC controllers via CAN-Bus, turning them into a dual esc effectively. No need for a servo Y-cable anymore. The master VESC transmits the signals to the slave VESC. All Digital of...
From €3.90 *